Ending No. for No. Series
When using No. Series – you do not need to set the Ending No. in No. Series unless there is a reason you would not want the number to go past that value.
If you do not clear the value – the system could eventually reach that value and it will not let you go past the value.
To clear the value, select Navigate, Lines
Remove the value in the Ending No. field
If you want to remove all Ending Nos. select Show system filters
This will show you the Series Code that it is filtered on
Select the x in front of the value to clear the filter
Then you can remove the Ending No. on all the lines